Nortel Networks NN43001-314 Password requirements, Installing an IP Phone using the keypad

Installing and conﬁguring IP Phones 265

At the Branch Ofﬁce, under a Branch User registration request (plugging

an IP Phone into a jack), the main ofﬁce Call Server checks the conﬁgured

terminal type against the IP Phone type and conﬁguration. This check

occurs at the Branch Ofﬁce.

At the main ofﬁce, under a Branch User registration request, the main ofﬁce

Call Server checks for a match of the conﬁguration to the IP Phone type. If

they do not match, registration is blocked.

Password requirements

Toconﬁgure Branch User-speciﬁc data from the IP Phone keypad, a main

ofﬁce password and a branch passwordare required.

If you conﬁgure an IP Phone Installer’s Passwordor a Temporary IP

Phone Installer’s Password, youcan delegate these tasks and continue to

conﬁgure the system based on CS 1000E Installation and Conﬁguration

NTP (NN43041-310). If the Branch Ofﬁce is a converted Small System,

refer to Communication Server 1000M and Meridian 1 Small System

Installation and Commissioning (NN43011-310).

Toinstall an IP Phone at the Branch Ofﬁce using Set-Based Installation,

Nortel strongly recommends that an IP Phone Installer’s Password or a

TemporaryIP Phone Installer’s Password be conﬁgured on the MG 1000B

Signaling Server. See Procedure 10 "Setting the IP Phone Installers

Password"(page 215) for information on conﬁguring the passwords.

Toconﬁgure the Branch User from an IP Phone in the main ofﬁce, one

of the following is required:

•IP Phone Installer’s Password or TemporaryIP Phone Installer’s

Password conﬁgured on the main ofﬁce Signaling Server. The

TemporaryIP Phone Installer’s Password is usually implemented to

enable a "trusted" user to install telephones at theMG 1000B.

•Station Control Password(SCPW) for the IP Phone conﬁgured on the

main ofﬁce Call Server. This is not the usual option, since usually a

trusted user or administrator installs IP Phones. An SCPW is a user

password.

Installing an IP Phone using the keypad

Before proceeding to install an IP Phone using the keypad, be sure to

obtain the required passwords, as described in "Passwordrequirements"

(page 265).

The procedure to install an IP Phone through the telephone interface

consists of three steps.

Nortel Communication Server 1000

Branch Ofﬁce Installation and Commissioning

NN43001-314 01.02 Standard

Release 5.0 20June 2007