Nortel Networks NN43001-314 Transferring IP Phone data using TM 3.01, Using the Reports and Import Facility in TM

274 MG 1000B telephones
CAUTION
Network Problems During Installation:
Setup:
The IP Phone in the Branch Office is on a different subnet
to the MG 1000B TPS and has a different route to the
main office. The MG 1000B TPS can connect to the main
office but the IP Phone cannot.
Symptom:
The terminal registers to the MG 1000B TPS and is
redirected to the main office (displaying the "Locating
Remote Server" message). When it does not successfully
register at the main office, it returns to the Branch Office
(displaying "Server Unreachable"). The terminal keeps
repeating the pattern.
Consequence:
The IP Phone does not successfully provide call service.
Diagnosis:
When this behavior is observed, check whether a ping
succeeds from the IP Phone’s subnet to the main office
TPS subnet.
CAUTION
After all IP Phones are installed, perform a datadump
(using LD 43 EDD or through NRS Manager) on the MG
1000BCP PM. Referto the Communication Server 1000E:
Installation and Configuration NTP (NN43041-310).
7Execute the EDD command in LD 43.
—End—
Transferring IP Phone data using TM 3.01
Provisioned data for MG 1000BIP Phones can be transferred directly from
the main office to the branch office using TM BUID and MOTN valuesare
then added. This transfer can be done by:
Using the Reports and Import Facility in TM
Step Action
1Create a report file to contain the exported station data:
•In TM WebStation, choose Telephones> Repor ts.
•In the Reports page, choose Customize.
Nortel Communication Server 1000
Branch Office Installation and Commissioning
NN43001-314 01.02 Standard
Release 5.0 20 June 2007
Copyright© 2007, Nor tel Networks
.