320 Emergency Services configuration
ESA uses a route number rather than ESN route list index. However,
ESN is required at the Branch Office.
4Configure Emergency Services Access (ESA) in LD 24.
Configure an ACD number as an Emergency Services Directory
Number.
LD 24 Configure Emergency Services Access.
Prompt Response Description
REQ NEW CHG Addnew data, or change existing data.
TYPE ESA Emergency Services Access data block
CUST xx Customer number as defined in LD 15
ESDN xxxx Emergency Services DN (for example, 911). Up to four digits
are accepted.
ESRT ESA route number
0-511 Range for Large System and CS 1000E system
0-127 Range for Small System and Media Gateway 1000B
DDGT x…xDirecting Digits (for example, 1, 11, or 911). Up to four digits
are accepted.
DFCL x…xDefault ESA Calling Number. The input must be the following
lengths:
•On a system that is not FNP equipped, 8 or 11 digits are
accepted if the first digit of the input is "1"; otherwise the
input must be 7 or 10 digits.
•On a system that is FNP equipped, up to 16 digits are
allowed.
OSDN x…xOn-Site Notification station DN. The input must be a valid
single appearance internal DN.
5Configure the Branch Office zone on the main office.
a. Configure the Branch Office zone’s ESA dialing information in
LD 117.
LD 117 Configure Branch Office zone ESA route.
Command Description
CHG ZESA <Zone><ESA Route #><AC><ESA Prefix><ESA Locator>
Defines the ESA parameters for the Branch Office zone, where:
•Zone = Zone number for the Branch Office.
Nortel Communication Server 1000
Branch Office Installation and Commissioning
NN43001-314 01.02 Standard
Release 5.0 20 June 2007
Copyright© 2007, Nor tel Networks
.