Nortel Networks SRG50 To enter the Motn and Buid, Field Values Description Firmware, Version

Chapter 4 CS 1000 considerations 49

Table 10 SRG S1000 IP Terminal Details fields (Sheet 2 of 2)

Field	Values	Description
Firmware	Read-only	Updated by the main office when a terminal is sent back to the SRG for
Version		firmware upgrade purposes. The field specifies the firmware version
		required by the main office.
MOTN	XXX	Required for telephone redirection.
		The field is the main office TN associated with the IP telephone.
BUID	CDP network: <DN>	Required for telephone redirection.
		The field represents the dialable number of an IP telephone at the SRG
	UDP network: <VoIP access	when it is called from a phone located at the main office or another
	code> + <LOC> + <DN>	branch office.
		The BUID at the SRG must be the same as the BUID at the main office.
MO TPS	Read-only	This field echoes the address of the main office terminal proxy server
		when the IP telephone is redirected.

Note: The SRG DNs must be configured before the following procedures can be undertaken. See Telephone (DN) records configuration on page 56.

To enter the MOTN and BUID

1In Element Manager, navigate to Configuration > Resources > Survivable Remote Gateway.

2Select the S1000 IP Terminal Details tab (see the figure S1000 IP Terminal Details panel on page 50).

3Refer to the numbers and models recorded in the table IP telephone numbers and models on page 47.

4Select the required DN.

5Press the Modify button.

6Enter the MOTN and the BUID in the appropriate fields.

To redirect the telephone to the main office call server

1In Element Manager, navigate to Configuration > Resources > Survivable Remote Gateway.

2Select the S1000 IP Terminal Details tab (see the figure S1000 IP Terminal Details panel on page 50).

3Select the DN of the telephone to be redirected.

4Press the Redirect Set button.

SRG50 Configuration Guide