6.4Assigning Units (UNIT)
When you are using scaling (SCL) or the square root setting (SQRT), it is possible to assign a different unit to the scales. Units will appear in the periodic printout. Up to six characters can be set.
The initial value is all spaces. To set, proceed as follows:
Key operation
ESC
DISP
3 sec
CH UP
CH UP
PRINT FEED
CH UP
Indication
Discription
Press the [DISP] key for three seconds to enter the SET mode.
Select the [ 
] display by using the [
] key. Then press the [ENT] key.
Specify the desired channel using the [
] key, and press the [ENT] key. If the selected channel is not of the SCL or SQRT- type, data entry will be ignored.
The maximum six characters of the unit can be set by the described code (Example is given in parentheses).
corresponding code of the character (B) sequential number of the character you are setting (2nd)
channel number (1)
| ESC |
|
CH UP | DISP | 3 sec |
|
|
Table of characters code.
0 | 1 | 2 | 3 | 4 | 5 | 6 | 7 | 8 |
0 |
| S P 0 |
| P |
| p |
| |
1 |
|
| 1 | A | Q | a | q |
|
2 |
|
| 2 | B | R | b | r |
|
3 |
| # | 3 | C | S | c | s |
|
4 |
|
| 4 | D | T | d | t |
|
5 |
| % | 5 | E | U | e | u |
|
6 |
|
| 6 | F | V | f | v |
|
77 G W g w
8 | ( | 8 | H | X | h | x |
9 | ) | 9 | I | Y | i | y |
A | * |
| J | Z | j | z |
B | + |
| K |
| k |
|
C |
|
| L | ∝ | l |
|
D | – |
| M |
| m |
|
|
|
|
|
|
|
|
E | . |
| N | Ω | n |
|
|
|
|
|
|
|
|
F | / | ˚ | O |
| o | Ω |
|
|
|
|
|
|
S/P means ‘SPACE’.
NOTE
The code number can be selected using the [
] key. After setting both numbers of a code, press the [ 
] key and the sequential number of the to be set character will go up one. After setting, press the [ENT] key.
[ 
] is displayed and the setting is completed. Press the [ENT] key to set another channel; or press the [DISP] key for three seconds to return to the OPERATION mode.
If you press the [ESC] key in the middle of setting, the
indication returns to the [
] and already set data will be aborted.
6 - 14
