7.17 Turning the Settings Protection Function On/Off

You can protect your settings made in the SET or SET UP modes using a password.

• If you select ‘OFF’:

the choice does not affect operation in any mode.

• If you select ‘ON’:

you must type in a password to enter the SET or SET UP mode. The password discussed here is one you set in the following procedure.

The initial value is ‘OFF.’

SETTING PROCEDURE:

Enter the SET UP mode by turning ‘ON’ the power while pressing and holding the [CH UP] (ENT) key until the SET UP display appears.

Use the [

] key to select the display [

]. Press the [ENT] key.

Use the [

] key to select ‘ON’ or ‘OFF’. Press the [ENT] key. In the case you

selected Off, the setting is completed.

 

Set a password in four-digits numerals using the [ ] key and the [ ] key. After

setting is finished, press the [ENT] key. The display [

] appears.

NOTE Never forget the password.

Before leaving the SET UP mode, you have to store your new settings. Use the [ ] key

to select the [ ] display, and press the [ENT] key.

Select [ ] to keep your new settings or [ ] to abort the settings, and press the [ENT] key. After a few seconds, the OPERATION mode will appear.

7 - 18

Page 89
Image 89
Omega RD260A instruction manual Turning the Settings Protection Function On/Off