6.1 Setting Input Range and Recording Span (RANGE)
Thermocouple and Resistance Temperature Detector Setting (TC, RTD Setting)
In the case that the measured signal is a TC (Thermocouple) or RTD (Resistance
Temperature Detector) the range can be set the same way as if it were a
Key operation | Indication | Description |
|
|
| |
ESC |
| Press the [DISP] key for three seconds to enter the SET mode. | ||||
DISP | 3 sec | Select the [ | ] display by using the [ | ] key. | ||
| ||||||
|
| Then press the [ENT] key. |
|
|
| |
|
|
|
|
|
| |
CH UP |
|
|
|
|
|
|
|
| Use the [ | ] key to select the desired channel. |
| ||
| Press the [ENT] key. |
|
|
| ||
CH UP |
|
|
|
|
|
|
|
| Use the [ | ] key to select [ | ], or [ | ]. |
|
| Press the [ENT] key. |
|
|
| ||
CH UP |
|
|
|
|
|
|
|
| Select the desired type (R, S, B, K, E, J, T, N, W, L, U in case | ||||
| of TC, or PT, JPT in case of RTD) using the [ | ] key and | ||||
|
| |||||
press the [ENT] key.
CH UP
TC Type Description and RTD Type Description
TC Type Description
| Range | |
| 0.0 to 1760.0° C | 32 to 3200° F |
| 0.0 to 1760.0° C | 32 to 3200° F |
| 0.0 to 1820.0° C | 32 to 3308° F |
| ||
| ||
| ||
| ||
| 0.0 to 1300.0° C | 32 to 2372° F |
| 0.0 to 2315.0° C | 32 to 4199° F |
RTD Type Description
|
| Range | |
(pt100Ω | ) | ||
(Jpt100Ω | ) | ||
FEED | ||
| CH UP |
|
| ESC |
|
CH UP | DISP | 3 sec |
|
| |
Select the desired minimum value (SPAN L) and maximum value of the recording span (SPAN R) in the same way as described under ‘VOLT setting’.
Note that the recording span cannot be beyond the input range, nor can SPAN L be equal to SPAN R.
[ 
] is displayed and the setting is completed. Press the [ENT] key to set another channel; or press the [DISP] key for three seconds to return to the OPERATION mode.
6. SET MODE
NOTE If you press the [ESC] key in the middle of setting, the indication returns to the
[
] and already set data will be aborted.
6 - 5
