7.13 Turning Printing of Channel Numbers On/Off (Dot-printing model)

If turned on, this function prints each channel number next to the measured value at approximately 25-mm intervals. The default value is ‘ON’.

Note that no channel number will be printed if the chart speed exceeds 120mm/h.

SETTING PROCEDURE:

Enter the SET UP mode by turning ‘ON’ the power while pressing and holding the [CH UP] (ENT) key until the SET UP display appears.

Use the [

] key to select the display [

]. Press the [ENT] key.

Use the [

] key to select the display [

]. Press the [ENT] key.

Using the [

] key, select either ‘ON’ or ‘OFF’ and then press the [ENT] key. The

display [

] will appear.

 

Before leaving the SET UP mode, you have to store your new settings. Use the [ ] key

to select the [ ] display, and press the [ENT] key.

Select [ ] to keep your new settings or [ ] to abort the settings, and press the [ENT] key. After a few seconds, the OPERATION mode will appear.

7 - 14

Page 85
Image 85
Omega RD260A instruction manual Setting Procedure