Configuring the Printer
3.2.1 Explanation of the Printout on the Previous Pages
In the headline behind the term VER2 the revision level of the printer's firmware can be found.
Then following the Printer Identification and in the next line a needle test.
The next part of the printout is a list of the MACRO settings.
In this case MACRO 1 is marked with an asterisk (*) which identifies it as the active macro.
Note: A “Macro“ is a summary of application specific parameter settings for a user. It is possible to have a total of three macros, each with a different summary of VALUE settings for different applications.
Whenever you make modifications in the active macro without saving them you will find the new settings under the heading CURRENT USER. Unless they are saved, the modifications will stay active only until the printer is switched off. When the printer is switched on again the macro settings marked with the asterisk will be reactivated.
Note: The CURRENT USER will be selected by MACRO 1, MACRO 2, or MACRO 3.
3.3Menu Structure
Press [STATION 2] and [COMPRESS
The Menu Mode starts with MENU SETUP in level 1.
OFF-LINE MODE
| Menu |
|
| Menu |
| Printing |
| |||
| Setup |
|
| Printing |
| Test |
| |||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |||
|
|
|
|
|
|
|
|
|
|
|
Select Current Macro |
|
|
| User’s Guide |
| |||||
Select User to Setup |
|
|
| ASCII Character Set |
| |||||
Configure |
|
|
| Character Attributes |
| |||||
IBM Configure |
|
|
| Dr. Grauert |
| |||||
LQ Configure |
|
|
|
|
|
|
| |||
|
|
|
|
|
|
| ||||
Save Parameters |
|
|
|
|
|
|
| |||
|
|
|
|
|
|
|
|
|
|
|
Photo Sensor Value
Left Margin
Top Margin
Run In Test
Bidirectional Aligment
Print Photo Values
Inquire Photo Values
Resume Hardware
Parameters
Debug/Test
Data Backup Mode
Printing Saved Data
Printing Last Data
Printing Flash Data
Directly Dump
Level 1
Info
Inquiring
Level 2
FW Version
HW Version
Printer ID
