|
|
| Appendix B IBM ProPrinter X24 and IBM ProPrinter II Commands | ||
|
|
|
| (IBM ProPrinter II) | |
ESC 3 |
|
| |||
n | |||||
Line Feed - n/216" |
| Hexadecimal code: 1B 33 n | |||
n = 1 - 255 |
|
|
Sets the n/216" (0,1176 x n mm) line feed.
This is the line feed recommended for graphic printing (BIM). If programmed to 24/216", it ensures that the various lines in
It remains valid until a new line feed command is received.
Note: To obtain precise line feeds, always use multiples of 3 for parameter n.
ESC A | n | (IBM ProPrinter X24) |
Line Feed - n/72" or n/60" | Hexadecimal code: 1B 41 n | |
n = 1 - 85 |
|
If the parameter AGM : NO has been selected in the SETUP,it sets the n/72" (0,3528 x n
mm)line feed; If the parameter AGM : YES has been selected in the SETUP ,it sets the n/60" (0,432 x n mm) line feed.
It will only be executed when the command ESC 2 is received. Until then, the current line feed remains valid.
Note: n = 0 does not change the current line feed.
ESC A | n | (IBM ProPrinter II) |
Line Feed - n/72" | Hexadecimal code: 1B 41 n | |
n = 1 - 85 |
|
Sets the n/72" (0,3528 x n mm) line feed.
It will only be executed when the command ESC 2 is received. Until then, the current line feed remains valid.
Note: n = 0 does not change the current line feed.