Output Solutions 650 Optional Devices, Add the second interface port, Working with dual-port

Options

5.Options

5.1Optional Devices

Following optional devices can be provided:

•Serial interface port 2

•USB interface (in preparation)

Add the second interface port

Printer has basic configuration of one standard serial and parallel communication interface. At the rear of printer there is a second interface installation slot, this slot is be used in the standard Version by the parallel interface. A special version of C-650 Plus can be provide without the parallel interface port.

This slot can be used than for option boards and cards as below:

•Second serial interface board and USB interface board

•Second serial interface board or

•USB interface board

Note: When printer equipped with second or more other data communication interface boards, interface working mode can be selected by menu setup configuration.

•Working with single communication port

•Printer can only work according to the interface mode and emulation selected by menu configuration, even if the printer has been equipped with more interface boards.

•Working with dual-port

•If the printer has been equipped with option interface board, the operator can set up printer working mode to be dual-port mode through the operator panel to meet different usage requirements.

•If the printer has been installed second serial port board and USB interface board, there are only two serial ports( first serial port and second serial port) can work synchronously. Under this configuration, printer can check which port is active. Any one of these two ports, if its data has been received, printer will be under the control of this port, and be kept in this state till this port task is end. Two ports are independent. And two ports have the same configuration except emulation mode. Emulation mode can be shifted by commands.

•If printer has been installed with second parallel interface board and configured as dual-port activity, it will check which port buffer has data. If any one of these two ports detect data has been received, printer will be under the control of the port and it will be kept in this state till port task is end. Dual-port functionality and corresponding parameters can be selected though operator panel. Under the especial circumstance, each port can have its own emulation mode, and using commands can shift emulation mode.

•If printer hardware configuration has two interface and the setup item interface in the menu is UAL then it can print out two interface corresponding emulation configuration in self-test sheet. Printer can set which port to be active and emulation mode according to host communication port.

5-1