Configuring the Printer
3.6ADJUSTMENT
Adjustment can be used to adjust and check some
Warning: The user who wants to adjust these parameters of the printer should be a professional engineer or be guided by a professional engineer.
User usually should not change the settings. If the printer has to be adapted, the user should have already well understood the involved parameters. Or else the printer may miss normal function. The following introduce the adjustable parameters.
These parameters below allow manipulation on operator panel:
•Photosensor Value (see paragraph 3.6.1)
• | Left Margin | (see paragraph 3.6.2) |
• | Top Margin | (see paragraph 3.6.3) |
• | Run In Test | (see paragraph 3.6.4) |
•Alignment Adjustment for Bidirectional Printing (see paragraph 3.6.5)
• | Printing Photosensor Value | (see paragraph 3.6.6) |
• | Inquire Photosensor Values | (see paragraph 3.6.7) |
• | Resume HW Parameters | (see paragraph 3.6.8) |
3.6.1 PHOTOSENSOR VALUE
All the photo sensor value has been adjusted to correct values in the factory, but after using it for many days, some unexpected change may happen for some reason, such as using unacceptable paper. In order to make the printer work correctly, please adjust the photo sensor value again.
After entering adjustment, you have to do the following steps:
Key or action | Two line display | |
Select Adjustment | ADJUSTMENT | |
| PHOTOSENSOR VALUE | |
|
| |
[STOP #] | PHOTOSENSOR VALUE | |
There is a noise of the rollers and the green lamp of Station 2 light up | INSERT SHEET; PRESS # | |
insert paper and press | PHOTOSENSOR VALUE | |
[STOP #] | INSERT SHEET; PRESS # | |
The printer insert the paper and start the setup of the photo sensor. | PHOTOSENSOR VALUE | |
Paper eject after adjustment. | END. PRESS # TO PRINT | |
[STOP #] | PHOTOSENSOR VALUE | |
INSERT A4 SHEET | ||
| ||
Insert paper; | PHOTOSENSOR VALUE | |
after print the values the paper will be eject | FINISH; PRESS STAT 2 | |
[STATION 2] | PHOTOSENSOR VALUE | |
| ||
|
|
