Configuring the Printer
3.6.8 RESUME HARDWARE PARAMETERS
All standard default settings of the firmware will be restored. The contents of the page counter will not be changed, but all other settings are reset.
|
|
| Key or action | Two line display | |
|
|
| Select Adjustment | ADJUSTMENT | |
|
|
|
| PHOTOSENSOR VALUE | |
|
|
|
|
|
|
|
|
| [COMPRESS | ADJUSTMENT | |
|
|
| until the LCD shows: | RESUME HW PARAMETERS | |
|
|
| [STOP #] to select | RESUME HW PARAMETERS | |
| The yellow Ready and green Station 1 and Station 2 lamp lights up. | # ACCEPT ST2 = IGNORE | |||
|
|
|
|
|
|
|
|
| Press[STOP #] to accept | ADJUSTMENT | |
|
|
| RESUME HW PARAMETERS |
| |
|
|
|
| ||
|
|
| or [STATION 2] to ignore. | ||
|
|
| ADJUSTMENT | ||
|
|
|
| ||
|
|
|
|
|
|
| If you want to leave the | SAVE PARAMETERS | |||
|
|
| [COMPRESS | # ACCEPT ST2 = IGNORE | |
|
|
|
|
|
|
|
| Press [STATION 2] to ignore. | CX LQ1600K | ||
|
| ||||
|
|
|
| ||
*) The displayed line is depending on the selected emulation.
3.7DEBUG / TEST
The Debug / Test parameter defines the execution of control sequences when Hex- printing has been activated. The incoming or stored data from the host are printed in hex mode. This is an excellent help for the programmer.
The Debug/ Test mode is arrange into two groups:
•Hex Printing
•Magnetic Test
In the Hex Printing mode we will find five groups:
•Data Backup Mode
•Printing Saved Data
•Printing Last Data
•Printing Flash Data
•Directly Dump
The HEX print is divided into three groups:
•1. the transmission code first with five bytes
•2. values of the data in HEX
•3. ASCII code of the printed data
1. | 2. | 3. |
Sample: 00000 | 00 0C 07 0D 07 0D 07 0D 07 0D 07 0D | 0 & C * C * C * C * C * |
