When using a V-mount type battery

Mount the V-mount adapter plate. Insert the plate and slide it as shown below.

• To remove the plate, slide the release lever downwards.

Preparation Chapter 5  

Release lever

Setting the battery type

•Select the battery type listed under BATTERY SELECT. Select the menu option BATTERY SELECT from the setting menu BATTERY SETUP screen.

•When using a battery not listed under BATTERY SELECT: If it is a NiCd battery, select “NiCd14 (14 V)” and set each item according to the battery characteristics. If it is not a NiCd battery, select TYPE A or TYPE B and set each item according to the battery characteristics. For details, refer to [BATTERY SETUP screen] (page 144).

NOTE

•For information about the V-mount adapter plate, please contact the store where you purchased the camera-recorder.

•With the V-mount adapter plate installed, % (percent) values cannot be displayed when using batteries that show the remaining battery capacity.

When using an NP battery

1 Mount a V-mount adapter plate on the camera.

Refer to [When using a V-mount type battery] (this page).

2

Attach a holder plate on the NP battery case.

 

• When the battery plate comes with a packing, first

 

insert the packing in the battery case.

 

(1)

Remove the screw at the bottom of the cover

 

 

and remove the cover.

 

(2)

Line up the openings in the battery case and

 

 

battery plate and use the supplied screws to

 

 

fasten the case to the plate.

 

(3)

Tighten the power supply connector screw.

 

(4)

Insert the removed top cover in the direction of

 

 

the arrow.

 

(5)

Line up the openings in the lower cover (metal

 

 

part) and the case and use the securing screw

 

 

to fasten them together.



  



96