9. Programmable Features
63
Sending a fax at a specific
time
{#}{4}{1}{2}
This feature allows you to take advantage of low-cost calling hours offered by
your telephone company. This feature can be set up to 24 hours in advance of
the desired time.
{0} “Off” (default)
{1} “On��
To send a document:
1. If the {Fax} light is OFF, turn it ON by pressing {Fax}.
2. Set the original (page 19).
3. {Menu} i {#}{4}{1}{2}
4. Press {1} to select “On”. i {Set}
5. Enter the fax number.
LTo enter an item using navigator directory, see steps 2 to 3 on
“6.3.1 Using the scanner glass”, page 45.
6. {Set}
7. Press {V} or {^} repeatedly to select “Time”. i {<}/{>}
8. Enter the transmission start time.
LPress {<} or {>} repeatedly to move the cursor, and then press {V} or
{^} repeatedly to select “AM” or “PM”.
9. {Set}
10.If necessary, change the resolution (page 42) and the contrast (page 42).
11.When using the scanne r gl ass, press {Start}. i {Start}
When using the automatic document feeder, press {Start}.
LThe document will be fed into the unit and scanned into memory. The
unit will then send the data at the specified time. You cannot use this
feature for another fax transmission until the former sending is
completed.
Note:
LTo cancel this setting after programming, press {Stop} while the unit is idle,
and then press {Set}.
Setting the Error Correction
Mode (ECM)
{#}{4}{1}{3}
This feature is available when the sending / receiving fax machines are ECM
compatible.
{0} “Off”: Deactivates this feature.
{1} “On” (default): Fax transmission / reception will be carried out so that the
errors do not occur.
Setting the connecting tone
{#}{4}{1}{6}
If you often have trouble when sending faxes, this feature allows you to hear
connecting tones: fax tone, ring back tone and busy tone. You can use these
tones to confirm the status of the other party’s machine.
{0} “Off”: Deactivates this feature.
{1} “On” (default): You will hear connecting tones.
Note:
LIf the ring back tone continues, the other party’s machine may not be a fax
machine or may have run out of paper. Check with the other party.
LThe connecting tone volume cannot be adjusted.
Setting the maximum fax
speed
{#}{4}{1}{8}
{1} “14.4Kbps”
{2} “33.6Kbps” (default)
Note:
LThe fax speed maybe lower than the selected speed depending on your
line.
Activating the Distinctive
Ring feature
{#}{4}{3}{0}
{0} “Off” (default)
{1} “On”
See page 56 for details.
Feature/Code Selection