Settings

[PROJECTOR SETUP] menu

10)Set [BRIGHTNESS CONTROL GAIN] of all projectors to 100%.

11)Set [BRIGHTNESS CONTROL GAIN] of the darkest projector to 90%.

12)Adjust [BRIGHTNESS CONTROL GAIN] to match the [BRIGHTNESS CONTROL GAIN] set to 90% of the other projectors.

13)Set [MODE] in [BRIGHTNESS CONTROL SETUP] of all projectors to [AUTO], and [LINK] to [GROUP A].

14)Select [APPLY] in [BRIGHTNESS CONTROL SETUP] on all projectors

and press the <ENTER> button. zzLuminance control starts.

Note

zzBrightness is automatically corrected each time the lamp blinks when the power is switched on or off.

zzAdjust luminance control again when variation in brightness has increased or a lamp is replaced.

[STANDBY MODE]

Set the power consumption during the standby.

1)Press ▲▼ to select [STANDBY MODE].

2)Press ◀▶ to switch [STANDBY

MODE].

zzThe setting will change as follows each time you press the button.

[NORMAL][ECO]

Note

zzWhen set to [ECO], network functions and <SERIAL OUT> terminal, and some RS-232C commands are not available during standby. The lighting for the connecting terminals and control panel does not turn on.

zzWhen an error or warning occurs, a self diagnosis is displayed on the control panel regardless of the [STANDBY MODE] setting. ( page 25)

zzWhen set to [ECO], the time taken to start display may be approximately ten seconds slower than compared to when set to [NORMAL].

[SCHEDULE]

Set the command execution schedule for each day of the week.

1) Press ▲▼ to select [SCHEDULE].

2) Press ◀▶ to switch [SCHEDULE]. zzThe setting will change as follows each time

you press the button.

[ON][OFF]

Note

zzIf [SCHEDULE] is set to [ON], the setting for [STANDBY MODE] is automatically set to [NORMAL] and cannot be changed. Even if [SCHEDULE] is then set to [OFF] when in this state, the setting of [STANDBY MODE] remains at [NORMAL].

■■How to assign a program

3) Select [ON] in Step 2), and press the <ENTER> button.

zzThe [SCHEDULE] screen is displayed.

4) Select and assign program to each day of week.

zzPress ▲▼ to select the day of week, and press ◀▶ to select a program number.

zzYou can set the program from No.1 to No.7. “-

--” indicates that the program number has not been set yet.

■■How to set a program

You can set up to 16 commands to each program.

3) Select [ON] in Step 2), and press the <ENTER> button.

zzThe [SCHEDULE] screen is displayed.

4)Press ▲▼ to select [PROGRAM EDIT].

5)Press ◀▶ to select a program number and then press the <ENTER> button.

6)Press ▲▼ to select a command number and press the <ENTER>

button.

zzYou can change the page using ◀▶ .

7)Press ▲▼ to select [TIME] and press the <ENTER> button.

8)Press ◀▶ to select hour and minute, and press ▲▼ or the number (<0> to <9>) buttons on the remote control to set a time, and press the <ENTER> button.

9)Press ▲▼ to select [COMMAND].

106 - ENGLISH