Switching on/off the projector

3)

5)

4)

 

 

 

 

 

8) 10) 11) 12)

 

3)

9)

 

 

 

 

 

 

 

 

5)

6)

 

 

 

 

 

 

 

 

 

4) 11)

8)

 

 

 

 

 

10) 12)

6)

9)

7)

1)

2)

 

Operation Basic

Switching on the projector

Install the projection lens before switching on the projector. ( page 43)

Remove the lens cover first.

1) Connect the power plug to an outlet.

(AC 200 V - 240 V 50 Hz/60 Hz)

2) Press the <ON> side of the <MAIN POWER> switch to turn on the power. zzThe power indicator <ON (G)/STANDBY (R)>

will light in red, and the projector will enter the standby mode.

3) Press the power on < > button. zzThe power indicator <ON (G)/STANDBY (R)>

will light in green and the image will soon be projected on the screen.

Attention

zzUsing the projector while the lens cover is attached may cause the device to heat up and result in a fire.

Note

zzIf the projector is switched on at about 0°C (32°F), a warm-up period of approximately five minutes may be necessary until a projection is displayed. The temperature indicator <TEMP> is lit during the warm-up period. When the warm-up is completed, the temperature indicator <TEMP> turns off and the projection starts. Refer to “Managing the indicated problems” ( page 142) for the indicator status.

zzIf the operating environment temperature is low and warm-up takes more than 5 minutes, the projector will judge that a problem has occurred and the power will automatically be set to stand-by. If this happens, increase the operating environment temperature 0°C (32°F) or higher, turn off the main power, and then turn on the power again.

zzIf the menu [PROJECTOR SETUP] → [STANDBY MODE] ( page 106) is set in the [ECO] menu, display will start approximately 10 seconds later compared to when [NORMAL] is selected.

Making adjustments and selections

It is recommended that images are projected continuously for at least 30 minutes before the focus is adjusted.

4) Press the <FOCUS> button to roughly adjust the focus of the image. ( page 52)

5) Set the projection method using [PROJECTION METHOD] ( page 99) and [COOLING CONDITION] ( page 100) on the menu.

zzRefer to “Navigating through the menu” ( page 61) for the operation of the menu screen.

6)Press the input selection (<RGB1>, <RGB2>, <DVI-D>, <VIDEO>, <HDMI>, <SDI 1/2>) buttons to select the input

signal. ( page 58)

(SDI input is only PT-DZ21KU, PT-DS20KU)

7)Adjust the front and back, and sideway tilt of the projector with the adjustable feet. ( page 42)

8)Press the <SHIFT> button to adjust the position of the image.( page 52)

9)If the input signal is RGB, press the <AUTO SETUP> button. ( page 59)

10)Press the <ZOOM> button to adjust the size of the image to match the screen. ( page 52)

11)Press the <FOCUS> button again to adjust the focus.

12)Press the <ZOOM> button again to adjust the zoom and the size of the image to match the screen.

50 - ENGLISH