Panasonic PT-DS20KU, PT-DW17KU, PT-DZ21KU [3D PICTURE BALANCE], [DARK TIME SETTING], MONITOR], ■■To display [3D WAVEFORM, [3D SETTINGS] menu (PT‑DZ21KU and PT‑DS20KU only)

[3D SETTINGS] menu (PT‑DZ21KU and PT‑DS20KU only)

[3D PICTURE BALANCE]

Correct a shift when the brightness or color differ in the right eye and left eye images.

1) Press ▲▼ to select [3D PICTURE

BALANCE].

2) Press the <ENTER> button. zzThe [3D PICTURE BALANCE] screen is

displayed.

3) Press ▲▼ to select an item, and press ◀▶ to adjust the setting.

zzCorrect the setting value parts of the right eye image based on the left eye image.

[CONTRAST]	You can adjust the contrast of the
	colors.
[WHITE	Adjusts the high red white
BALANCE HIGH
	balance.
RED]
[WHITE	Adjusts the high green white
BALANCE HIGH
	balance.
GREEN]
[WHITE	Adjusts the high blue white
BALANCE HIGH
	balance.
BLUE]
[BRIGHTNESS]	You can adjust the dark (black)
	part of the projected image.
[WHITE
BALANCE LOW	Adjusts the low red white balance.
RED]
[WHITE	Adjusts the low green white
BALANCE LOW
	balance.
GREEN]
[WHITE	Adjusts the low blue white
BALANCE LOW
	balance.
BLUE]
[COLOR]	You can adjust the color saturation
	of the projected image.
[TINT]	You can adjust the skin tone in the
	projected image.
[CLOCK	Adjust when the screen flickers or
PHASE]	outline blurs.

Note

zz[CLOCK PHASE] settings go are enabled at simultaneous input of RGB1 and RGB2 to adjust the right eye image.

zzThis is disabled when [3D SYSTEM SETTING] is set to any setting other than [SINGLE].

zzThis is disabled when [3D TEST PATTERN] is displayed.

zzThis is disabled when [3D TEST MODE] is set to any setting other than [NORMAL] and [SIDE BY SIDE].

■■To display [3D WAVEFORM

MONITOR]

The left eye and right eye images are divided and displayed in a waveform on the left and right.

4)Select [3D WAVEFORM MONITOR] in Step 3).

5)Press ◀▶ to switch [3D WAVEFORM

MONITOR].

zzThe setting will change as follows each time you press the button.

[OFF]		[ON]
[OFF]	The 3D waveform monitor is not
	displayed.
[ON]	The 3D waveform monitor is
	displayed.

Note

zzThe 3D waveform monitor is displayed only when the [3D PICTURE BALANCE] screen is displayed. zzThe normal waveform monitor cannot be displayed

in 3D images.

[DARK TIME SETTING]

Set the black display period to be displayed between the right eye image and the left eye image as necessary for the 3D system used.

1)Press ▲▼ to select [DARK TIME

SETTING].

2)Press ◀▶ to switch [DARK TIME

SETTING].

zzThe setting will change as follows each time you press the button.

[0.5 ms]	[1.0 ms]	[1.5 ms]
[2.7 ms]	[2.5 ms]	[2.0 ms]

Note

zzThis is disabled when [3D SYSTEM SETTING] is set to any setting other than [SINGLE].

zzWhen the setting does not correspond to the 3D system in use, phenomenon such as increased crosstalk and darkening of displayed images may occur.

Settings

ENGLISH - 85