[PROJECTOR SETUP] menu[PROJECTOR SETUP] menu

Select [PROJECTOR SETUP] from the main menu, and select the item from the sub-menu. Refer to “Navigating through the menu” ( page 61) for the operation of the menu screen.

zzAfter selecting the item, press ▲▼◀▶ to set.

[PROJECTOR ID]

The projector has an ID number setting function that can be used when multiple projectors are used side by side to enable simultaneous control or individual control via one remote control.

1) Press ▲▼ to select [PROJECTOR ID].

2) Press ◀▶ to switch [PROJECTOR ID]. zzThe setting will change as follows each time

you press the button.

[ALL][1]

[64][2]

Note

zzThe ID number can be set to a value from [ALL], [1] to [64].

zzTo specify an ID number for individual control, the ID number of a remote control must match the ID number of the projector.

zzWhen the ID number is set to [ALL], the projector will operate regardless of the ID number specified during remote control or computer control. If multiple projectors are set up side by side with IDs set to [ALL], they cannot be controlled separately from the projectors with other ID numbers.

zzRefer to “Setting Remote control ID numbers” ( page 27) regarding the method to set the ID number on the remote control.

[PROJECTION METHOD]

Set the projection method in accordance with the installation status of the projector.

Change the projection method if the screen display is upside down or inverted.

1) Press ▲▼ to select [PROJECTION

METHOD].

2) Press the <ENTER> button. zzThe [PROJECTION METHOD] screen is

displayed.

3)Press ▲▼ to select the projection method.

[FRONT/FLOOR] When installing on the desk, etc., in front of the screen

When installing using the

[FRONT/CEILING] ceiling mount bracket (optional accessories) in front of the

screen

When installing on the desk,

[REAR/FLOOR] etc., behind the screen (using a translucent screen)

When installing using the

[REAR/CEILING] ceiling mount bracket (optional accessories) behind the screen

(using a translucent screen)

4)Press the <ENTER> button.

5)When the confirmation is displayed, select [OK] or [CANCEL], and press the <ENTER> button.

Attention

zzWhen [PROJECTION METHOD] is changed, confirm that [COOLING CONDITION] ( page 100) is set correctly.

Settings

ENGLISH - 99