■■To use a colorimeter to adjust the color matching

Use a colorimeter that can measure chromaticity coordinates and luminance to change the colors [RED], [GREEN], [BLUE], [CYAN], [MAGENTA], [YELLOW], and [WHITE] to desired colors.

zzInputting the current luminance and chromaticity coordinates

1) Press ▲▼ to select [COLOR

MATCHING].

2) Press ◀▶ to select [709MODE] or [MEASURED].

3) Press the <ENTER> button. zzThe [709MODE] or [MEASURED MODE]

screen is displayed.

4) Press ▲▼ to select [MEASURED

DATA].

5) Press the <ENTER> button.

zzThe [MEASURED DATA] screen is displayed.

6) Measure the luminance (Y) and the chromaticity coordinates (x, y) using the colorimeter.

7) Press ▲▼ to select a color, and press ◀▶ to adjust the setting.

zzSet [AUTO TESTPATTERN] to [ON] to display a test pattern of selected colors.

8) Once all the input is completed, press the <MENU> button.

zzThe [709MODE] or [MEASURED MODE] screen is displayed.

zzInputting the coordinates of desired colors (for [MEASURED] only)

9) Press ▲▼ to select [TARGET DATA].

10) Press the <ENTER> button. zzThe [TARGET DATA] screen is displayed.

11)Press ▲▼ to select a color and press ◀▶ to input coordinates for desired

colors.

zzSet [AUTO TESTPATTERN] to [ON] to display a test pattern of selected colors.

12)Once all the input is completed, press the <MENU> button.

Note

zzWhen [709MODE] is selected in [COLOR MATCHING], the ITU-R BT.709 standard three primary colors are set as target data.

zzColors are not displayed properly when target data is a color outside the region of this projector.

zzThe [709MODE] may differ slightly from the ITU-R BT.709 standard colors.

[DISPLAY OPTION] menu

zzSet the [AUTO TESTPATTERN] to [ON] to automatically display a test pattern for use in adjusting the selected adjustment colors.

zzBefore using a colorimeter or similar instrument to measure measurement data, set [PICTURE MODE] to [DYNAMIC].

zzA difference in the color coordinates of target data and measurement values obtained from an instrument may occur for certain instruments and measurement environments used.

zzThe [AUTO TESTPATTERN] setting s change in conjunction with the [AUTO TESTPATTERN] settings in [EDGE BLENDING].

[LARGE SCREEN CORRECTION]

Corrects the phenomenon in which colors that appear lighter when viewed on a large screen viewed from a close distance compared to when viewed on an average screen size so that colors appear the same.

1)Press ▲▼ to select [LARGE SCREEN

CORRECTION].

2)Press ◀▶ to switch [LARGE SCREEN

CORRECTION].

zzThe setting will change as follows each time you press the button.

[OFF] (No

 

[1] (Low)

 

[2] (High)

correction)

 

 

 

 

 

 

 

 

 

 

 

Settings

ENGLISH - 89