Operation Basic

Projecting

Check the projection lens attachment ( page 43), external device connection ( page 44), power cord connection ( page 48), switch on the power ( page 50) to start projecting. Select the video for projection, and adjust appearance of the projected image.

Select the input signal

Select an input signal.

1) Switch on the external devices.

zzPress the play button on an external device, such as a Blu-ray disc player.

2) Press the input selection (<RGB1>, <RGB2>, <DVI-D>, <VIDEO>, <HDMI>, <SDI 1/2>) buttons on the control panel or the remote control.

zzThe image of the signal being input in the selected terminal is projected.

Attention

zzImages may not be projected properly depending on the external device, or the blu-ray disc or DVD disc, to be played back. Set [PICTURE]→[SYSTEM SELECTOR] ( page 70) on the menu.

zzConfirm the aspect ratio of the projection screen and the image, and switch to an optimum aspect ratio from the [POSITION] menu → [ASPECT] ( page 72).

Adjusting the focus, zoom, and shift

If the projected image or the position is not correct when the positioning of the projector and the screen is correctly installed, adjust the focus, zoom, and shift.

■■On the projector

1) Press the <LENS> button on the control panel.

zzPressing the button changes the setup screen in the order of “lens focus”, “lens zoom”, and “lens shift”.

2) Select each item and press ▲▼◀▶ to adjust it.

■■Using the remote control

1) Press the lens (<FOCUS>, <ZOOM>, <SHIFT>) buttons on the remote control.

zz<FOCUS> button: Adjusts focus.

zz<ZOOM> button: Adjusts zoom.

zz<SHIFT> button: Adjusts shift.

2) Select each item and press ▲▼◀▶ to adjust it.

Note

zzZoom adjust menu will not be displayed when the projection lens without the zoom function is attached.

zzUse the projection lens ET-D75LE5, ET-D75LE50 with the lens position on the home position. ( page 53) zzThe adjustment can be performed faster by pressing and holding ▲▼◀▶ while adjusting the focus and shift. zzIt is recommended that images are projected continuously for at least 30 minutes before the focus is adjusted. zzOnly “lens focus” is shown in yellow so that the displayed menu item can be recognized by color, even when

the projector is not focused and displayed characters are unreadable. (Factory default)

Displaying the color of “lens focus” varies depending on the setting of [OSD DESIGN] ( page 94) on the menu. zzWhen the power is switched off during focus and shift adjustment, lens calibration needs to be performed the

next time the power is switched on. ( page 111)

zzWhen the main power is switched off during focus adjustment, lens calibration is performed automatically during the next focus adjustment.

zzWhen the main power is switched off during shift adjustment, a lens calibration error screen will be displayed during the next shift adjustment. Run [LENS CALIBRATION] ( page 111) from the menu.

zzWhen the lens calibration error is displayed even though [LENS CALIBRATION] was executed, ask your dealer to repair the unit.

52 - ENGLISH