Settings
[ADVANCED MENU]
[INPUT RESOLUTION]You can adjust to achieve an optimal image when there is a flickering image or smeared outlines.
1) Press ▲▼ to select [INPUT
RESOLUTION].
2) Press the <ENTER> button. zzThe [INPUT RESOLUTION] screen is
displayed.
3)Press ▲▼ to select [TOTAL DOTS], [DISPLAY DOTS], [TOTAL LINES], or [DISPLAY LINES], and press ◀▶ to
adjust it.
zzValues corresponding to the input signal are displayed automatically for each item. Change the displayed values and adjust to the optimal point viewing the screen when there is a vertical banding or missing in the screen.
Note
zzPreviously mentioned vertical banding will not occur with all white signal input.
zzThe image may be disrupted while performing the adjustment, but it is not a malfunction.
zz[INPUT RESOLUTION] can be adjusted only when a signal is input to the <RGB 1 IN> terminal or the <RGB 2 IN> terminal.
zzCertain signals may not be adjustable.
[CLAMP POSITION]You can adjust the optimal point when the black part of the image is blunt or it has turned green.
1) Press ▲▼ to select [CLAMP
POSITION].
2) Press ◀▶ to adjust the level. zzAdjust the level to a value from [1] to [255].
zzOptimal value of clamp position adjustment When the black part is blunt:
The point where bluntness of the black part improves the most is the optimal value. When the black part is green:
The point where the green part becomes black, and the bluntness has improved is the optimal value.
Note
zz[CLAMP POSITION] can be adjusted only when a signal is input to the <RGB 1 IN> terminal or the <RGB 2 IN> terminal.
zzCertain signals may not be adjustable.
The edge blending function allows multiple projector images to be seamlessly overlapped by using the inclination of the brightness at the overlapped area.
1)Press ▲▼ to select [EDGE
BLENDING].
2)Press ◀▶ to switch [EDGE
BLENDING].
zzThe setting will change as follows each time you press the button.
[OFF] |
|
| [ON] |
| [USER] |
|
|
| |||
[OFF] |
| Sets the edge blending function to | |||
| off. |
|
| ||
|
|
|
| ||
[ON] |
| Use the setting value of the internal | |||
| distortion of the set for the inclination | ||||
|
| of the edge blending area. | |||
|
| Use the | |||
[USER] |
| inclination of the edge blending area. | |||
| (Configuration/registration requires | ||||
|
| separate software. Consult your | |||
|
| dealer.) |
|
| |
3) Press the <ENTER> button.
zzThe [EDGE BLENDING] screen is displayed.
4) Press ▲▼ to specify the location to be corrected.
zzWhen joining at top: Set [UPPER] to [ON].
zzWhen joining at bottom: Set [LOWER] to [ON].
zzWhen joining at left: Set [LEFT] to [ON].
zzWhen joining at right: Set [RIGHT] to [ON].
5)Press ◀▶ to switch [ON]and [OFF].
6)Press ◀▶ to adjust correction width and starting point.
78 - ENGLISH