Paradyne 8779, U8777 Copy Ports Options, Table A-6. Copy Port Options, From Port n, To Port y

A. Configuration Options

Copy Ports Options

You can copy the configuration options of one DSX-1 or G.703 interface, or DSL loop to another using the Copy Ports screen. For Copy Ports options, refer to Table A-6, Copy Port Options. To access the Copy Ports screen, follow this menu selection sequence:

Main Menu → Configuration → Current Configuration → Copy Ports

main/config/copy
Slot: 18	Model: 87xx

COPY PORTS

From: Port 1

To: Port 2

Perform Copy

Perform Copy Then Increment

--------------------------------------------------------------------------------

ESC for previous menu	MainMenu	Exit
Save

Table A-6. Copy Port Options

From: Port n

Possible Settings: 1, 2, 3, 4, 5, 6, 7, 8

Default Setting: 1

Controls the source of the configuration options.

1 – 8 – The configuration of the selected port is copied.

To: Port y

Possible Settings: 1, 2, 3, 4, 5, 6, 7, 8, All

Default Setting: 1

Controls the target of the configuration options.

1 – 8 – The configuration of the selected port is replaced. If Perform Copy Then Increment is selected, the port number is incremented by 1 after the copy.

All – The configurations of all ports are replaced by the configuration of the selected

From: Port.

NOTE: Peer IP Address and Circuit Identifier are not copied.

A-12 May 2002 8700-A2-GB20-40