Paradyne 8779, U8777 manual Snmp Traps Options

A. Configuration Options

SNMP Traps Options

An SNMP trap can be automatically sent out through the EOC or the Management port to the SNMP manager when the unit detects conditions set by the user. These traps enable the SNMP manager to gauge the state of the network. Refer to Appendix B, Standards Compliance for SNMP Traps, for details of SNMP traps supported by the Hotwire Termination Unit.

o configure the unit for SNMP traps, use the SNMP Traps Options screen to:

Enable SNMP traps.

Set the number of SNMP managers that receive SNMP traps from the unit.

Enter an IP address and network destination for each SNMP manager

Tspecified.

Select the type of SNMP traps to be sent from the unit.

To access the SNMP Traps Options screen, follow this menu selection sequence:

Main Menu → Configuration → Current Configuration →

Management and Communication → SNMP Traps

main/config/management/trap
Slot: 4				Model: 87xx
			SNMP TRAPS OPTIONS
SNMP Traps:		Enable		Number of Trap Managers: 9
NMS 1 IP Address:		135.014.040.001		Clear
NMS 2 IP Address:		135.014.003.027		Clear
NMS 3 IP Address:		135.014.001.008		Clear
NMS 4 IP Address:		135.014.002.024		Clear
NMS 5 IP Address:		204.128.146.035		Clear
NMS 6 IP Address:		135.014.003.028		Clear
NMS 7	IP Address:	135.014.001.009		Clear
NMS 8	IP Address:	135.014.002.025		Clear
NMS 9	IP Address:	204.128.146.036		Clear

General Traps:	Both	Enterprise	Specific Traps:	Disable
Link Traps:	Both	Link Traps	Interfaces:	All

-------------------------------------------------------------------------------

Ctrl-a to access these functions, ESC for previous menu	MainMenu Exit
Save

A-34 May 2002 8700-A2-GB20-40