Paradyne 8779, U8777 manual See G.703 Interface Options

7. Monitoring and Troubleshooting

Table 7-1. Health and Status Messages (4 of 4)

Message	What Message Indicates	What To Do
Primary Clock Failed,	A failure has occurred in the	1.	Verify that the network cable
Pt n	primary clock source for the		is securely attached at both
	DSX-1 or G.703 port.		ends.
		2.	Verify the clock configuration
			on the unit and attached
			equipment.
		3.	Contact network provider.
Primary System Clock	A failure has occurred in the	Contact your service
Failed	clock common to all	representative.
	cross-connect circuitry.
RAI at G.703,	An RAI (Remote Alarm	1.	Check the status of the
Pt n	Indication) signal is being		attached device.
	received by the G.703	2.	Verify that the Line Coding,
	interface.
			Line Framing, and Time Slot
			16 configuration options
			selected are compatible with
			the connected G.703
			equipment’s configurations.
			See G.703 Interface Options
			(Model 8779) in Appendix A,
			Configuration Options.
Secondary System	A failure has occurred in the	Contact your service
Clock Failed	fallback clock for the system	representative.
	clock.
System Operational	There are no problems	No action is needed.
	detected.
Yellow Alarm at	A Yellow Alarm Indication	1.	Verify that the unit’s line
DSX-1, Pt n	signal is being received by		framing and line coding are
	the DSX-1 interface.		compatible.
		2.	Contact network provider.

7-6 May 2002 8700-A2-GB20-40