Paradyne U8777, 8779 manual Completed successfully

9.Transferring Firmware and Configurations Using TFTP

2.Position the cursor in the TFTP Server IP Address field. Enter the TFTP server IP address or M1 for the MCP FFS.

The first three digits of the IP address cannot be 000 or greater than 223.

3.Position the cursor in the TFTP Transfer Direction field. Use the spacebar to select Download from Server or Upload to Server.

4.For an LTU, go to Step 5. For an NTU, position the cursor in the Destination field. Use the spacebar to select a network destination for the TFTP server. Select DSL if the TFTP server destination is the DSL link port or IMC (Internal Management Channel) if the TFTP destination is the Management port of the MCC card.

5.Position the cursor at the Start Transfer field. Use the spacebar to select Yes. Press Enter.

When the data transfer is complete, the Transfer Status field changes to

Completed successfully.

6.Position the cursor at the Activate new configuration? prompt and select Yes to activate a new downloaded configuration. Press Enter.

NOTE:

The following options are not changed:

—DSL Mode and Telnet Session configuration options

—Peer IP address

You must change these settings with the appropriate configuration menus after the new configuration is activated. See Table A-7, System Options, and Table A-12, Telnet Session Options, in Appendix A, Configuration Options.

8700-A2-GB20-40 May 2002 9-5