Paradyne 8779, U8777 manual May

B. Standards Compliance for SNMP Traps

The tests that affect the enterpriseTestStart and enterpriseTestStop traps and the variable bindings depend on the interface. The specific tests and variable bindings are described in the following table.

	enterpriseTestStart/Stop
Interface	variable bindings		Possible Cause
			T
DSL Network	ifIndex (RFC 2863)		enterpriseTest Start – Any one
	ifAdminStatus (RFC 2863)		of the following tests is active
			on the interface:
	ifOperStatus (RFC 2863)		–	Line Loopback
	TifType (RFC 2863)		–	Repeater Loopback
	ifTestType (RFC 2863)		–	Remote Line Loopback
			– Send and Monitor 511
	The following objects control tests
	in SNMP-managed devices:		enterpriseTest Stop – No tests
	– noTest(0) – Stops the test in		currently running on the
		progress.	interface.
	–	testLoopLLB(4) – Initiates a
		Local Loopback.
	–	testLoopRLB(5) – Initiates a
		Repeater Loopback.
	–	testSendMon511(6) – Initiates a
		Send and Monitor 511 test.
	–	testSendLLBUp(7) – Initiates an
		LLB Up message to the remote
		unit.
	–	testSendLLBDown(8) – Initiates
		an LLB Down message to the
		remote unit.
DSX-1 or	ifIndex (RFC 2863)		enterpriseTest Start – Any one
G.703	ifAdminStatus (RFC 2863)		of the following tests is active
			on the interface:
	ifOperStatus (RFC 2863)		–	DTE Loopback
	TifType (RFC 2863)		–	Telco Payload Loopback
	ifTestType (RFC 2863)		T	(DSX-1 only)
			enterpriseTest Stop – No tests
	The following objects control tests
			currently running on the
	in SNMP-managed devices:
			interface.
	– noTest(0) – Stops the test in
		progress.
	–	testLoopDTLB(3) – Initiates a
		DTE Loopback.
	–	testLoopPLB(1) – A
		Telco-initiated Payload
		Loopback is active on the
		interface (DSX-1 only).

B-6 May 2002 8700-A2-GB20-40