Paradyne 8779, U8777 manual Completed successfully

3. Initial Startup and Configuration

2.Position the cursor in the TFTP Server IP Address field. Enter the TFTP server IP address or M1 for the MCP FFS.

The first three digits of the IP address cannot be 000 or greater than 223.

3.Position the cursor in the TFTP Transfer Direction field. Use the spacebar to select Download from Server or Upload to Server.

4.For a Line Termination Unit (LTU), go to Step 5. For a Network Termination Unit (NTU), position the cursor in the Destination field. Use the spacebar to select a network destination for the TFTP server. Select DSL if the TFTP server destination is the DSL link port or IMC (Internal Management Channel) if the TFTP destination is the Management port of the MCC.

5.Position the cursor at the Start Transfer field. Use the spacebar to select Yes. Press Enter.

When the data transfer is complete, the Transfer Status field changes to

Completed successfully.

6.Position the cursor at the Activate new configuration? prompt and select Yes to activate a new downloaded configuration. Press Enter.

NOTE:

Configuration options DSL Mode and Telnet Session are not changed when a new configuration is loaded. You must change these settings with the appropriate configuration menus after the new configuration is activated. See Table A-7, System Options, and Table A-10,Cross-Connect Mode Options – Model 8779, in Appendix A, Configuration Options.

3-8 May 2002 8700-A2-GB20-40