Primera Technology 510212 manual Print Pressure Bracket

Digital Label Press 3 User’s Manual

7.Locate the Print Pressure Bracket indicated in the illustration below. This bracket runs the entire width of the printer's interior and must be removed in order to load print media into the press.

Print Pressure

Bracket

8.The Print Pressure Bracket is held in place by two Securing Levers and is connected to the printer electronically by its Sensor Connector. Each of these items is marked with a yellow colored end. To remove the bracket, first turn the printer power OFF, then disconnect the Sensor Connector by sliding it toward the left-hand side of the printer until it stops.

Securing Lever

9.Next, firmly pull up on each Securing Lever until each is in its fully opened position as shown above. Some force is required to unlatch these Securing Levers. Note that lifting both the left and right Securing Levers simultaneously may reduce the effort required to unlatch the levers.

26

Section 4: Ribbon and Print Media