Q-Logic 59042-07 A manual Topology, Displays all connected devices, Users

B – Command Line Interface			0
Show Command
	Table B-16. Switch Operational Parameters (Continued)
		Parameter	Description
	LogLevel		Event severity level used to record
			events in the event log
	MaxPorts		Number of ports available on the switch
	NumberOfResets		Number of times the switch has been
			reset over its service life
	ReasonForLastReset		Action that caused the last reset
	ActiveImageVersion - build date		Active firmware image version and build
			date.
	PendingImageVersion - build date		Firmware image version and build date
			that is pending. This image will become
			active at the next reset or power cycle.
	ActiveConfiguration		Name of the switch configuration that is
			in use.
	AdminState		Switch administrative state
	AdminModeActive		Admin session status
	BeaconOnStatus		Beacon status as set by the Set Beacon
			command.
	OperationalState		Switch operational state
	PrincipalSwitchRole		Principal switch status. True indicates
			that this switch is the principal switch.
	BoardTemp (1) - Degrees Celsius		Internal switch temperature at circuit
			board sensor 1
	BoardTemp (2) - Degrees Celsius		Internal switch temperature at circuit
			board sensor 2
	SwitchDiagnosticsStatus		Results of the power-on self test
	SwitchTemperatureStatus		Switch temperature status: normal,
			warning, failure

topology

Displays all connected devices.

users

Displays a list of logged-in users. This is equivalent to the User List command.

B-64 59042-07 A