B – Command Line Interface

0

 

 

Set Setup Command

 

 

 

 

 

 

 

 

 

 

 

 

 

Table B-13. SNMP Configuration Settings (Continued)

 

 

 

 

 

Entry

Description

 

 

 

 

 

 

ReadCommunity

Read community password that authorizes an SNMP agent

 

 

 

 

to read information from the switch. This is a write-only field.

 

 

 

 

The value on the switch and the SNMP management server

 

 

 

 

must be the same. The read community password can be up

 

 

 

 

to 32 characters excluding #, semicolon (;), and comma (,).

 

 

 

 

The default is “public”.

 

 

WriteCommunity

Write community password that authorizes an SNMP agent

 

 

 

 

to write information to the switch. This is a write-only field.

 

 

 

 

The value on the switch and the SNMP management server

 

 

 

 

must be the same. The write community password can be

 

 

 

 

up to 32 characters excluding #, semicolon (;), and comma

 

 

 

 

(,). The default is “private”.

 

 

TrapCommunity

Trap community password that authorizes an SNMP agent

 

 

 

 

to receive traps. This is a write-only field. The value on the

 

 

 

 

switch and the SNMP management server must be the

 

 

 

 

same. The trap community password can be up to 32

 

 

 

 

characters excluding #, semicolon (;), and comma (,). The

 

 

 

 

default is “public”.

 

 

AuthFailureTrap

Enables (True) or disables (False) the generation of traps in

 

 

 

 

response to trap authentication failures. The default is False.

 

 

ProxyEnabled

Enables (True) or disables (False) SNMP communication

 

 

 

 

with other switches in the fabric. The default is True.

 

 

 

 

 

 

system

Prompts you in a line-by-line fashion to change system configuration settings. Table B-14describes the system configuration fields. For each parameter, enter a new value or press the Enter key to accept the current value shown in brackets.

Note: Changing the IP address will terminate all Ethernet management sessions.

Table B-14. System Configuration Settings

Entry

Description

 

 

Eth0NetworkDiscovery

Ethernet boot method: 1 - Static, 2 - Bootp, 3 -

 

DHCP, 4 - RARP. The default is 1 - Static.

Eth0NetworkAddress

Ethernet Internet Protocol (IP) address. The

 

default is 10.0.0.1.

 

 

B-54

59042-07 A

Page 144
Image 144
Q-Logic 59042-07 A manual Table B-14. System Configuration Settings