Q-Logic 59042-07 A manual Lipalpdalps

0			B – Command Line Interface
			Show Command
	Table B-15. Show Port Parameters (Continued)
	Entry	Description
	EpConnects	Number of times an E_Port connected through ISL
		negotiation.
	FBusy	Number of times the switch sent a F_BSY because Class 2
		frame could not be delivered within ED_TOV time. Number
		of class 2 and class 3 fabric busy (F_BSY) frames
		generated by this port in response to incoming frames.
		This usually indicates a busy condition on the fabric or
		N_Port that is preventing delivery of this frame.
	Flowerrors	Received a frame when there were no available credits.
	FReject	Number of frames from devices that were rejected.
	InvalidCRC	Invalid CRC detected.
	InvalidDestAddr	Invalid destination address detected.
	LIP_AL_PD_ALPS	Number of F7, AL_PS LIPs, or AL_PD (vendor specific)
		resets, performed.
	LIP_F7_AL_PS	This LIP is used to reinitialize the loop. An L_Port,
		identified by AL_PS, may have noticed a performance
		degradation and is trying to restore the loop.
	LIP_F8_AL_PS	This LIP denotes a loop failure detected by the L_Port
		identified by AL_PS.
	LIP_F7_F7	A loop initialization primitive frame used to acquire a valid
		AL_PA.
	LIP_F8_F7	A loop initialization primitive frame used to indicate that a
		loop failure has been detected at the receiver.
	Link Failures	Number of optical link failures detected by this port. A link
		failure is a loss of synchronization or a loss of signal while
		not in the offline state. A loss of signal causes the switch to
		attempt to re-establish the link. If the link is not
		re-established, a link failure is counted. A link reset is
		performed after a link failure.
	Login	Number of device logins
	Logout	Number of device logouts
	LoopTimeouts	A two (2) second timeout as specified by FC-AL-2.
	LossOfSync	Number of synchronization losses (>100 ms) detected by
		this port. A loss of synchronization is detected by receipt of
		an invalid transmission word.

59042-07 A B-61