Q-Logic 59042-07 A manual Table B-10. Set Config Switch Parameters

B – Command Line Interface		0
Set Config Command
	Table B-9. Set Config Port Parameters (Continued)
	Parameter	Description
	IOStreamGuard	I/O Stream Guard. Enables or disables the
		suppression of RSCN messages. IOStreamGuard can
		have the following values:
		„ Enable – Suppresses the reception of RSCN
		messages from other ports for which
		IOStreamGuard is enabled.
		„ Disable – Allows free transmission and reception
		of RSCN messages.
		„ Auto – Suppresses the reception of RSCN
		messages under the following conditions: 1) The
		port is connected to an initiator device with a
		QLogic HBA, 2) The DeviceScanEnable
		parameter is enabled. Auto is the default.
	PDISCPingEnable	Enables (True) or disables (False) the transmission of
		ping messages from the switch to all devices on a
		loop port. The default is True.

switch

Initiates an editing session in which to change switch configuration settings. The system displays each parameter one line at a time and prompts you for a value. For each parameter, enter a new value or press the Enter key to accept the current value shown in brackets. Table B-10describes the Set Config Switch parameters.

Table B-10. Set Config Switch Parameters

Parameter	Description
AdminState	Switch administrative state: online,
	offline, or diagnostics. The default is
	Online.
BroadcastEnabled	Broadcast. Enables (True) or disables
	(False) forwarding of broadcast frames.
	The default is True.
InbandEnabled	Inband management. Enables (True) or
	disables (False) the ability to manage
	the switch over an ISL. The default is
	True.

B-40 59042-07 A