Q-Logic 59042-07 A manual Port LEDs, Port Logged-In LED, Port Activity LED

2 – General Description	0
Fibre Channel Ports

2.2.1

Port LEDs

Each Fibre Channel port has its own Logged-In LED and Activity LED as shown in Figure 2-5.

Logged-In	Activity LED
LED (Green)	(Green)

Figure 2-5. Port LEDs

2.2.1.1

Port Logged-In LED

The Logged-in LED indicates the logged-in or initialization status of the connected devices. After successful completion of the POST, the switch extinguishes all Logged-In LEDs. Following a successful loop initialization or port login, the switch illuminates the corresponding logged-in LED. This shows that the port is properly connected and able to communicate with its attached devices. The Logged-In LED remains illuminated as long as the port is initialized or logged in. If the port connection is broken or an error occurs that disables the port, the Logged-In LED will flash. Refer to “Logged-In LED Indications” on page 5-5for more information about the Logged-In LED.

2.2.1.2

Port Activity LED

The Activity LED indicates that data is passing through the port. Each frame that the port transmits or receives causes this LED to illuminate for 50 milliseconds. This makes it possible to observe the transmission of a single frame. When extending credits, the Activity LED for a donor port will reflect the traffic of the recipient port. Refer to “Distance” on page 3-4for more information about extended credits and donor ports.

2-6 59042-07 A