Q-Logic 59042-07 A manual Switch, Shown, When you are done making changes to the switch

0		B – Command Line Interface
	Working with Switch Configurations
	The Show Switch command displays the name of the active configuration. A
	configuration name can have up to 31 characters excluding the pound symbol (#),
	semicolon (;), and comma (,). By editing the latest configuration and saving the
	results under a new name, you can create a history of configuration changes. Use
	the Config List command to display the names of the configurations stored on the
	switch
	SANbox2 #> config list
	Current list of configurations
	------------------------------
	default
	config_10132003
	To modify a switch configuration you must open an Admin session with the Admin
	Start command. An Admin session prevents other accounts from making changes
	at the same time either through Telnet or SANsurfer Switch Manager. You must
	also open a Config Edit session with the Config Edit command and indicate which
	configuration you want to modify. If you do not specify a configuration name the
	active configuration is assumed. The Config Edit session provides access to the
	Set Config commands with which you make modifications to the port, switch, port
	threshold alarm, or zoning configuration components as shown:
	SANbox2 #> admin start
	SANbox2 (admin) #> config edit default
	The config named default is being edited.
	SANbox2 (admin-config)#> set config port . . .
	SANbox2 (admin-config)#> set config switch . . .
	SANbox2 (admin-config)#> set config threshold . . .
	SANbox2 (admin-config)#> set config zoning . . .
	The Config Save command saves the changes you made during the Config Edit
	session. In this case, changes to the configuration named Default are being saved
	to a new configuration named config_10132003. However, the new configuration
	does not take effect until you activate it with the Config Activate command as
	shown:
	SANbox2 (admin-config)#> config save config_10132003
	SANbox2 (admin)#> config activate config_10132003
	SANbox2 (admin)#> admin end
	SANbox2 #>
	The Admin End command releases the Admin session for other administrators
	when you are done making changes to the switch.

59042-07 A B-3