Q-Logic 59042-07 A manual Reset Command, Config configname

B – Command Line Interface	0
Reset Command

Reset Command

Resets the switch configuration parameters. If you omit the keyword, the default is Reset Switch.

Authority	Admin session
Syntax	reset
	config [config_name]
	factory
	port [port_number]
	snmp
	switch (default)
	system
	zoning
Keywords	config [config_name]
	Resets the configuration given by [config_name] to the factory default values for
	switch, port, port threshold alarm, and zoning configuration. If [config_name] does
	not exist on the switch, a configuration with that name will be created. If you omit
	[config_name], the active configuration is reset. You must activate the
	configuration for the changes to take effect. Refer to Table B-3through Table B-6
	for switch, port, and port threshold alarm configuration default values.
	factory
	Resets switch configuration, port configuration, port threshold alarm configuration,
	zoning configuration, SNMP configuration, system configuration, and zoning to
	the factory default values. The switch configuration is activated automatically.
	Refer to Table B-3through Table B-8.

Note: Because this keyword changes network parameters, the workstation could lose communication with the switch and release the Admin session.

port [port_number]

Reinitializes the port given by [port_number]. Ports are numbered beginning with 0.

snmp

Resets the SNMP configuration settings to the factory default values. Refer to Table B-7for SNMP configuration default values.

switch

Resets the switch without a power-on self test. This is the default. This reset disrupts traffic and does the following:

„Activates the pending firmware.

„Closes all management sessions.

B-30 59042-07 A