
0 | 5 – Diagnostics/Troubleshooting |
| |
| POST Diagnostics |
|
|
|
|
5.1.1.3
Configuration File System Error Blink Pattern
A configuration file system error blink pattern is 4 blinks followed by a two second pause. The
2 seconds
To recreate the configuration file, do the following:
CAUTION! Recreating the configuration file will delete all switch configuration settings.
1.Open a Telnet session and use the Shutdown command to close activity on the switch, then power down the switch. Refer to the “Shutdown Command” on page
2.Place the switch in maintenance mode. Press and hold the Maintenance button for
3.Establish a Telnet session with the switch using the default IP address 10.0.0.1.
telnet 10.0.0.1
4.Enter the account name (prom) and password (prom), and press the Enter key.
Sanbox2 login: prom Password:xxxx [username@host:Itasca]% telnet 10.0.0.1 Trying 10.0.0.1...
Connected to 10.0.0.1. Escape character is '^]'.