Roland SC-88 Pro ■Initialize, MENT [l] [r] buttons, ●Initialize for GM/GS, 2. To initialize, press [ALL], 2. To initialize, press [ALL]

■Initialize

●Initialize all Parts to the factory settings

This procedure will initialize all the settings of this unit to the factory settings. This will also initialize System parameters (p.36) and User parameters (p.96).

1. While holding down [SELECT], simultaneously press both the INSTRU-MENT [l] [r] buttons.

The display will ask “Init All, Sure?”.

2. To initialize, press [ALL].

To quit without initializing, press [MUTE].

*After the initialization has been performed, the indications in the display for the parameters listed below will show the factory default settings. In fact, however, the settings will not yet at that point be at the defaults. They will be placed at the defaults after you turn power on, then off again.

In Mode, OUT/THRU, IN B Sel. ( p.135)

●Initialize for GM/GS

When you wish to playback song data carrying the GM/GS logo, you need to initialize this unit for GM/GS settings. When this is done, this unit will be set to the basic GM/GS settings appropriate for playing back song data carrying the GM/GS logo.

The beginning of song data carrying the GM/GS logo contains data which requests the sound source to initialize itself (General MIDI System On, GS Reset p.133). This means that if you are playing back the song data from the beginning, initialization will be done automatically, and there is no need for you to do it using the front panel buttons.

*Even if this unit is initialized for GS/GM, the System parameter settings (p.36) will not be affected.

*Even if the Backup Switch ( p.37) is on, the following procedure will rewrite it to the factory setting.

1.(For GM) While holding down [SELECT], press PART [r].(For GS) While holding down [SELECT], press INSTRUMENT [r].

The display will ask “Init GM, Sure?” or “Init GS, Sure?”

If you perform this operation in Double Module mode (p.116), the display will ask “Init GS A, Sure?”. Use INSTRUMENT [l] [r] to specify which module A or B will be ini-

tialized.

2. To initialize, press [ALL].

To quit without initializing, press [MUTE].

		2	1GM	1 ALL
			PART	INSTRUMENT
		ALL		1GS
			LEVEL	PAN
		MUTE
			REVERB	CHORUS
		SC-55
		MAP	KEY SHIFT	MIDI CH
		SC-88
	1	MAP
			DELAY
		VIB RATE	VIB DEPTH	VIB DELAY
USER			CUTOFF	RESONANCE
INST	SELECT	ATTACK	DECAY	RELEASE
EFX	ON/OFF	EFX TYPE	EFX PARAM	EFX VALUE

118 Chapter 5. Convenient functions