Schneider Electric VW3A3310d Access to Ethernet menu via graphic display terminal, Ent

7. Ethernet menu

7. 1. Access to Ethernet menu via graphic display terminal

The [ETHERNET] submenu is used to configure and display the Ethernet card parameters and can be accessed via the [1.9 - COMMUNICATION] menu.

If you are using the FDR (Faulty Device Replacement) function, you must also configure the device name in the [7. DISPLAY CONFIG.] menu, [7.1 USER PARAMETERS] submenu, [DEVICE NAME] submenu.

This menu is only accessible in expert mode: In the [2 ACCESS LEVEL] (LAC-)menu, set the level to [expert] (EPr).

RDY	NET +0.00 Hz 0A
	MAIN MENU

1 DRIVE MENU

2 ACCESS LEVEL

3 OPEN / SAVE AS

4PASSWORD

5LANGUAGE

CodeQuick

RDY NET +0.00 Hz 0A

1 DRIVE MENU

1.1 SIMPLY START

1.3SETTINGS

1.4MOTOR CONTROL

1.5INPUTS/OUTPUTS CFG

	Code	<<	>>	Quick
	1.6 COMMAND
	1.7 APPLICATION FUNCT.
ENT	1.8 FAULT MANAGEMENT

1.9 COMMUNICATION 1.10 DIAGNOSTICS

1.11 IDENTIFICATION

1.12 FACTORY SETTINGS

1.13 USER MENU

1.14 PROGRAMMABLE CARD

	RUN	NET	+50.00 Hz	80A
		1.9 COMMUNICATION
	COM. SCANNER OUTPUT
	MODBUS HMI
	MODBUS NETWORK
ENT	CANopen
	ETHERNET
	Code	<<	>>	Quick

7. 2. Access to Ethernet menu via the integrated display terminal

The (EtH-)submenu is used to configure and display the Ethernet card parameters. It can be accessed via the (COM-)menu.

Note: The device name required for the FDR (Faulty Device Replacement) function cannot be configured via the integrated display terminal.

Power-up

XXX

Displays the drive state

ENT
ESC
SIM-
ESC
FLt-
ESC	ENT
	EtH-
CON-
	ESC
ESC
FCS-
ESC
LAC-

12