O T H E R C O N V E N I E N T F E A T U R E S
KITCHEN TIMER
Use the Kitchen Timer as a minute timer or to monitor the standing time for cooked/defrosted food.
•Suppose you want to set the kitchen timer for 5 minutes.
P R O C E D U R E
1 Enter the desired time.
2 Press Info/Timer once.
NOTE:
In Energy Save Mode, Open and close the door to activate Kitchen Timer before entering the desired time.
INFO
Info key provides 8 features.
In F1: Drain | In F5: Child lock |
In F2: Descale | In F6: Sound on/off |
In F3: Water hardness | In F7: Clock |
In F4: Demo | In F8: Energy save mode |
The number from “In F1” to “In F8” will be displayed when you select the feature.
These features can be selected by pressing Info/ Timer and the desired function number and pressing Minute Plus/START.
DRAIN
The remaining water inside the steam generator can be evaporated by using the DRAIN function. See page 16.
DESCALE
See page 16.
MINUTE PLUS
Auto minute allows you to operate the two following functions:
a) Direct start
You can directly start cooking on 100% microwave power for 1 minute by pressing Minute Plus/START.
NOTE:
To avoid the misuse by children Minute Plus can be used only within 3 minutes after preceding operation, i.e., closing the door, pressing the Stop/Clear key or cooking completion.
b) Extend the manual cooking time
You can extend the manual cooking time for multiples of 1 minute if Minute Plus/START is pressed while the oven is in operation.
NOTE:
You can not use this function for Steam cooking. The cooking time can be extended up to 99 minutes.
WATER HARDNESS
Your oven is set at the factory to water hardness setting 2 (hard). You can set the oven for the water hardness level.
You can use a test strip available at some drug stores, to check the water hardness level.
In some areas, it is possible to ask the water supply company for the water hardness.
When you use test strips, follow the instructions of them.
Hardness level | Hardness range | Setting | |
|
|
| |
1 | <120 ppm | Soft | |
<120 mg/l | |||
|
| ||
| <6.7 °dH |
| |
2 | 120 - 250 ppm | Hard | |
120 - 250 mg/l | |||
|
| ||
| 6.7 - 14.0 °dH |
| |
3 | >250 ppm | Very hard | |
>250 mg/l | |||
|
| ||
| >14.0 °dH |
|
P R O C E D U R E
1 Press Info/Timer and the number 3 to select
Water Hardness. “In F3” will be displayed.
2 Press same number 3 until desired hardness level is displayed and press Minute Plus/
START.
The water hardness setting will be held in the memory even if the oven power is off.
30