5 BOP / AOP (Option)

Issue 10/06

BOP / AOP (Option)

Buttons and their Functions

Panel/

Function

Effects

 

 

Button

 

 

 

 

 

 

Indicates

The LCD displays the settings currently used by the converter.

 

Status

 

 

 

 

 

 

 

Pressing the button starts the converter. This button is disabled by default.

 

Start

Activate the button:

 

 

 

BOP: P0700 = 1 or P0719 = 10 ... 16

 

 

 

converter

 

 

 

AOP: P0700 = 4 or P0719 = 40 ... 46

on BOP link

 

 

 

 

 

P0700 = 5 or P0719 = 50 ... 56

on COM link

 

 

OFF1

Pressing the button causes the motor to come to a standstill at the

 

 

 

selected ramp down rate.

 

 

 

Stop

 

Activate the button: see button "Start converter"

 

OFF2

Pressing the button twice (or once long) causes the motor to coast

 

converter

 

 

to a standstill.

 

 

 

 

 

 

 

 

 

 

BOP: This function is always enabled

 

 

 

(independent of P0700 or P0719).

 

Change

Press this button to change the direction of rotation of the motor. Reverse is

 

indicated by a minus (-) sign or a flashing decimal point. Disabled by default.

 

direction

 

Activate the button: see button "Start converter".

 

 

 

 

In the "Ready to power-on" state, when this key is pressed, the motor starts

 

Jog motor

and rotates with the pre-set jog frequency. The motor stops when the button

 

 

is released. Pressing this button when the motor is running has no effect.

This button can be used to view additional information.

 

 

It works by pressing and holding the button. It shows the following, starting

 

 

from any parameter during operation:

 

 

1. DC link voltage (indicated by d – units V).

 

 

2.

output current. (A)

 

 

3.

output frequency (Hz)

 

 

4. output voltage (indicated by o – units V).

 

 

5. The value selected in P0005 (If P0005 is set to show any of the above

 

Functions

 

(1 - 4) then this will not be shown again).

 

Additional presses will toggle around the above displays.

 

 

 

 

Jump Function

 

 

From any parameter (rxxxx or Pxxxx) a short press of the Fn button will

 

 

immediately jump to r0000, you can then change another parameter, if

 

 

required. Upon returning to r0000, pressing the Fn button will return you to

 

 

your starting point.

 

 

Acknowledgement

 

 

If alarm and fault messages are present, then these can be acknowledged by

 

 

pressing key Fn.

 

Access

Pressing this button allows access to the parameters.

 

parameters

 

Increase

Pressing this button increases the displayed value.

 

value

 

 

 

 

Decrease

Pressing this button decreases the displayed value.

 

value

 

 

 

+

AOP menu

Calls the AOP menu prompting (this is only available for AOP).

26

MICROMASTER 440

Operating Instructions (Compact)

Page 26
Image 26
Siemens 440 operating instructions Buttons and their Functions