Installing Advanced Server for UNIX

Installing server software (asxserver package)

If the server is not started, the following message gives you information on how to upgrade later:

Access Control Entries can be upgraded from the LAN Manager 2.x accounts file (/var/opt/lanman/datafiles/accounts.lm2) after the user accounts and groups have been replicated to this backup controller.

You will need to manually run lmxupgrade -A ... after this has occurred.

In this case, the administration files must be adjusted after Advanced Server for UNIX has been started.

ÊStart AS/X with asx start.

ÊUse the net user command to check whether the account data has already been trans- ferred to this backup domain controller. If it has not been transferred, you can start the transfer using the command net accounts /sync. If there are problems transferring the account data, you may have to call /var/opt/lanman/bin/joindomain to re-establish the connection again.

ÊIf the account data has been updated on this backup domain controller, the access permissions must be created for Advanced Server for UNIX. Call

/var/opt/lanman/bin/lmxupgrade -YA.

Watch the output of the command for files and directories which are not found for upgrading access permissions.

4.8.4Upgrade installation of a primary domain controller from Version 3.5 or 4.0

To upgrade a primary domain controller from a previous Advanced Server for UNIX version, proceed as follows. In contrast to an upgrade installation from Version 2.x, the data can be upgraded directly; no conversion has to be done.

ÊLog on as system administrator root.

ÊStart the installation procedure as described in the section “Installing from CD-ROM with cdinst”.

ÊSelect the asxserver package under AS/X.

Stop the server

ÊChoose y to stop the server.

Product Manual

U7613-J-Z815-6-76

Page 71
Image 71
Siemens V4.0 manual Var/opt/lanman/bin/lmxupgrade -YA