Sierra Wireless DART 200 CDPD Modem manual Enter Online Mode, Select Register

DART 200 CDPD Modem User’s Guide F DART AT Command Set

Table F-1. Commands beginning with letters (cont.)

I (cont.) Result codes:
OK	Valid argument
ERROR	Invalid argument
NOT ENABLED	Must be in service provider mode

OEnter Online Mode

Instructs the DART to return to the online state. Any following commands on the same command line are ignored. This command is used to get to online mode following an ATD; command, or to return to online mode following an escape.

NOTE:

To return to SLIP mode following an escape from SLIP use AT*S.

Format:
ATO	Go/return to online mode
Result codes:
ERROR	Connection does not exist
CONNECT	Successful return to online mode

Q Quiet Mode

Controls whether result codes are sent to the Mobile Application Subsystem (MAS). If selected, result codes can be further modified by the V and X commands.

Format:
ATQ0	Disable quiet mode (result codes are sent to the MAS) (default)
ATQ1	Enable quiet mode (result codes are not sent to the MAS)

NOTE:

There are some low intelligence devices (often found when retrofitting CDPD to a landline or radio based system) that cannot accept any result codes. Q1 is an appropriate setting for that class of device.

Result codes:
<nothing>	If ATQ1 selected; OK response is suppressed
OK	If ATQ0 selected
ERROR	Invalid argument

SSelect Register

Selects a register for interrogation or modification in the current active profile. Subsequent reads or writes to the register are accomplished with the ? or = commands, respectively. The S command is normally used with an appended ? or = . The register remains selected until the next ATS command. The complete set of S-Registers is described in Appendix E.

Format:
ATSn	Select register <n>
Result codes:
OK	Valid register selected
ERROR	Unsupported register

Sierra Wireless, Inc. F-6