Sierra Wireless DART 200 CDPD Modem manual Set Subscriber Identity, Registered as a pair

DART 200 CDPD Modem User’s Guide F DART AT Command Set

Table F-3. Commands beginning with backslash (\) (cont.)

\R Format: (cont.)

AT\R2

AT\R3

AT\R4

AT\R5

Result codes:

OK

ERROR

NOT ENABLED

Register when connection is established, deregister when connection is terminated. Can be used only if the modem is operating as a client.

Turn off \R2 option

Auto-register when modem is powered on. If S-Register 13 is set to zero this option puts the modem into automatic registration mode.

Turn off \R4 option

Command successful

Unsuccessful completion; see S-Register 56

PIN Required; see *E command

\S	Set Subscriber Identity
	Displays the modem's NEI (IP Address) list (or configuration), and also to select or deselect, the NEI to
	be used for network registration. It supports both point-to-point (normal) and multicast (if being used)
	IP Addresses. The CDPD Service Provider provides the IP addresses.
	NOTE:
	The multicast NEI must be selected prior to registering the point to point NEI since they must be
	registered as a pair.

Format:

AT\Sn

AT\S+n

Select the NEI in slot <n> as the active IP Address, where <n> = 0 - 9.

Select the NEI in slot <n> as the multicast IP Address. The active NEI slot may not be selected.

AT\S-n

AT\S?

Result codes:

OK

ERROR

De-select address <n> as the active or multicast NEI

Display the IP Address list. The active NEI is marked by an <*>, the selected multicast NEI is marked by a <+>

Valid argument

Invalid argument

PN1197-00 Revision 1.0 F-17