Sierra Wireless DART 200 CDPD Modem manual Force PIN Usage, Set Multicast Group ID Gmid

DART 200 CDPD Modem User’s Guide F DART AT Command Set

Table F-6. Service Provider commands beginning with caret (^) (cont.)

^F	Force PIN Usage
	Enables the application developer to specify whether or not modem users require PINs. If the carrier
	does not require PINs, they can still be required by the user with the AT\P+ command.
	Format:
	AT^F0	PIN usage is not required (default).
	AT^F1	PIN usage is required.
	Result codes:
	OK	Valid argument
	ERROR	Invalid argument
	NOT ENABLED	Modem is not in service provider mode
^G	Set Multicast Group ID (GMID)
	Attaches a GMID to the user-defined multicast NEI. It must reference the slot in the NEI table where
	the multicast NEI is located.

The GMID is a carrier assigned value and is used by the MDIS, when the multicast NEI is registered, to put the NEI into the specified multicast group list. Packets directed to the multicast group are forwarded to all registered group members regardless of their current location.

Format:

AT^G<g>/<n>

AT^G-<n>

Result codes:

OK

ERROR

NOT ENABLED

where <g> = 0 to 65535

<n> = 0 to 9; default is 0; (see AT^A)

example: AT^G250/2

This form of the AT^G command is used to remove the GMID in slot n of the NEI list.

Valid argument

Invalid argument

Modem is not in service provider mode

^H	Set Service Provider Identifier (SPI)
	Loads an SPI into one of the 10 slots (numbered 0 - 9) in the DART’s SPI table: it applies in CDPD
	1.1 mode only. See the \J command in Chapter 2, Installation and Setup, Initial testing, for more
	information.
	Format:
	AT^H<s>/<n>	where <s> = 0 to 65535

<n> = 0 to 9; default is 0; (see AT^A)

AT^H-<n>

AT^H?

example: AT^H250/0

This form of the AT^H command is used to remove the SPI in slot n of the modem’s SPI table.

Display current SPI table entries

PN1197-00 Revision 1.0 F-27