Sierra Wireless DART 200 CDPD Modem manual Set the Service Provider Network ID Spni

DART 200 CDPD Modem User’s Guide F DART AT Command Set

Table F-6. Service Provider commands beginning with caret (^) (cont.)

^H	Result codes:
(cont.)	OK
		Valid argument
	ERROR	Invalid argument
	NOT ENABLED	Modem is not in service provider mode
^I	Set the Service Provider Network ID (SPNI)
	Loads a SPNI into one of the 10 slots (numbered 0 - 9) in the DART’s SPNI table. Refer to the \J
	command in Chapter 2, Installation and Setup, Initial testing, for more information.
	Format:
	AT^I<i>/<n>	where: <i> = 0 to 65535
		<n> = 0 to 9; default is 0; (see AT^A)

AT^I-<n>

AT^I?

Result codes:

example: AT^I250/0

This form of the AT^I command is used to remove the SPNI in slot n of the SPNI table.

Display current SPNI table entries

OK	Valid argument
ERROR	Invalid argument
NOT ENABLED	Modem is not in service provider mode

^L	Set the Local Service Area ID (LSAI) for CDPD 1.0 mode, or the Wide Area
	Service Identifier (WASI) for CDPD 1.1 mode
	Loads the LSAI or the WASI into one of the 10 slots (numbered 0 - 9) in the DART’s LSAI/WASI
	table. Refer to the \J command in Chapter 2, Installation and Setup, Initial testing, for more
	information.
	Format:
	AT^L<w>/<n>	where: <w> = 0 to 65535
		<n> = 0 to 9; default is 0; (see AT^A)

AT^L-<n>

AT^L?

Result codes:

example AT^L250/0

This form of the AT^L command is used to remove the WASI in slot n of the LSAI/WASI table.

Display current LSAI/WASI table entries

OK	Valid argument
ERROR	Invalid argument
NOT ENABLED	Modem is not in service provider mode

Sierra Wireless, Inc. F-28