Sierra Wireless DART 200 CDPD Modem Set PIN Requirement Change PIN, Set Flow Control Operation

DART 200 CDPD Modem User’s Guide F DART AT Command Set

Table F-3. Commands beginning with backslash (\) (cont.)

\P	Set PIN Requirement; Change PIN
	Allows the user to require, not require, or change the modem’s PIN. The PIN is used as a password to
	prevent unauthorized access to the CDPD network. Refer to Chapter 3, CDPD Security Features,
	Modem security management, and the AT*E command. The current PIN value cannot be displayed.
	The default PIN value is 0000.
	The use of a PIN can be required with the AT^F command.
	Format:
	AT\P+<current PIN>	Require PIN
	AT\P-<current PIN>	Do not require PIN (this is the default setting)
	AT\P=<current PIN>,	The new PIN replaces the current PIN
	<new PIN>, <new PIN>
	Result codes:
	OK	Valid argument
	ERROR	Invalid argument, or function in conflict with ^F command
	BLOCKED	Command ignored (see AT*U command)
\Q	Set Flow Control Operation
	Specifies the flow control method used by the DART. Refer to Chapter 8, Application Programming,
	Flow control considerations, for more information
	Format:
	AT\Q0	No flow control
	AT\Q1	Bi-directional XON/XOFF flow control
	AT\Q2	Hardware flow control (default)
	AT\Q3	Both
	Result codes:
	OK	Valid argument
	ERROR	Invalid argument
\R	Network Registration Control
	Causes the modem to register or deregister with the CDPD network. Upon deregistration, any
	outstanding connection is terminated and the DART can no longer participate in network operations.
	S-Register 13 contains the registration timeout value (default = 60 seconds). An S13 value of zero in
	combination with the \R4 option puts the DART into automatic registration mode. Refer to Chapter 8,
	Application Programming, Automatic registration, for more information.
	Format:
	AT\R0	Deregister from the network. Also resets automatic registration mode until the
		modem is reset.
	AT\R1	Register as an active MES on the network (default)

Sierra Wireless, Inc. F-16