Sierra Wireless DART 200 CDPD Modem manual Enable/Disable Reception of Cdpd Broadcasts

DART 200 CDPD Modem User’s Guide F DART AT Command Set

Table F-4. Commands beginning with asterisk (*) (cont.)

*B	Enable/Disable Reception of CDPD Broadcasts
	Enables or disables the reception of IP broadcast packets. Refer to Chapter 4, Broadcast and Multicast
	Operation, for more information.
	Format:
	AT*B0	Disable CDPD broadcast reception (default)
	AT*B1	Enable CDPD broadcast reception
	Result codes:
	OK	Valid argument
	ERROR	Invalid argument
*C	Enable/Disable SLIP Header Compression
	Enables or disables SLIP mode header compression (V-J compression) between the MAS and the DART
	modem. The setting for this parameter must match the compression setting in the TCP/IP stack in the
	MAS for SLIP to be operational.
	Format:
	AT*C0	Disable SLIP TCP header compression
	AT*C1	Enable SLIP TCP header compression (default)
	Result codes:
	OK	Valid argument
	ERROR	Invalid argument
*E	Enable/Disable Network Operations
	If PINs are required for network access, this command enables and disables access to the network.
	Use of PINs can be required by the AT\P+ or the AT^F1 command. If required, access to the CDPD
	network is denied until the proper PIN number is entered with the AT*E+ command. Specifically the
	Register (AT\Rn) and the Dial (ATDx) commands are not allowed. Once the PIN is entered, network
	access is allowed until the modem is power cycled, or until access is disabled by the AT*E- command.
	The modem becomes BLOCKED after three consecutive incorrect PIN entries are made. This condition
	can be cleared with the AT*U command.
	Format:
	AT*E+<pin>	PIN entry; the user is prompted for the PIN when establishing connection to the
		network. The default PIN value is 0000.
	AT*E-	Disallow network access commands and require PIN reentry in order to reestablish
		network connection.
	Result codes:
	OK	Valid argument
	ERROR	Invalid argument
	BLOCKED	Command ignored

PN1197-00 Revision 1.0 F-19