SMC Networks SMC6224M manual Command Usage

CONFIGURING THE SWITCH

automatically negotiate a trunked link with LACP-configured ports on another device. You can configure any number of ports on the switch as LACP, as long as they are not already configured as part of a static trunk. If ports on another device are also configured as LACP, the switch and the other device will negotiate a trunk link between them. If an LACP trunk consists of more than eight ports, all other ports will be placed in a standby mode. Should one link in the trunk fail, one of the standby ports will automatically be activated to replace it.

Command Usage

Besides balancing the load across each port in the trunk, the other ports provide redundancy by taking over the load if a port in the trunk fails. However, before making any physical connections between devices, use the web interface or CLI to specify the trunk on the devices at both ends. When using a port trunk, take note of the following points:

•Finish configuring port trunks before you connect the corresponding network cables between switches to avoid creating a loop.

•You can create up to four trunks on a switch or stack, with up to eight ports per trunk.

•The ports at both ends of a connection must be configured as trunk ports.

•When configuring static trunks on switches of different types, they must be compatible with the Cisco EtherChannel standard.

•The ports at both ends of a trunk must be configured in an identical manner, including communication mode (i.e., speed, duplex mode and flow control), VLAN assignments, and CoS settings.

•All the ports in a trunk have to be treated as a whole when moved from/to, added or deleted from a VLAN.

•STP, VLAN, and IGMP settings can only be made for the entire trunk.

3-94