SMC Networks SMC6224M manual Saving Configuration Settings, Trap Receivers

BASIC CONFIGURATION

2.To remove an existing string, simply type “no snmp-server community string,” where “string” is the community access string to remove. Press <Enter>.

Console(config)#snmp-server community admin rw

Console(config)#snmp-server community private

Console(config)#

Trap Receivers

You can also specify SNMP stations that are to receive traps from the switch. To configure a trap receiver, complete the following steps:

1.From the Privileged Exec level global configuration mode prompt, type “snmp-server host host-addresscommunity-string,” where “host-address” is the IP address for the trap receiver and “community-string” is the string associated with that host. Press <Enter>.

2.In order to configure the switch to send SNMP notifications, you must enter at least one snmp-server enable traps command. Type “snmp-server enable traps type,” where “type” is either authentication or link-up-down. Press <Enter>.

Console(config)#snmp-server enable traps link-up-down

Console(config)#

Saving Configuration Settings

Configuration commands only modify the running configuration file and are not saved when the switch is rebooted. To save all your configuration changes in nonvolatile storage, you must copy the running configuration file to the start-up configuration file using the “copy” command.

To save the current configuration settings, enter the following command:

1.From the Privileged Exec mode prompt, type “copy running-config startup-config” and press <Enter>.

2-13